Quantcast
Channel: Pdf Repair Manual Download » cutting tool
Viewing all articles
Browse latest Browse all 2

SKYROOF LSS Electric Spoiler Sunroof with Sliding Panel Shade Installation Manual

0
0

download
SUNROOF KIT PREPARATION 1. Verify that sunroof kit is complete and undamaged. 2. Bench test the sunroof to ensure proper operation. Close the glass fully before continuing. 3. Cover the vehicle interior to keep clean and prevent damage. SUNROOF INSTALLATION 4. Position the sunroof : Place the interior shade tray against the interior headliner and position to avoid any obstructions, allowing 4 inches clearance in front for the motor. Consider obstructions hidden by the headliner such as roof header, side rails and cross bows. NOTE: motor can be located above most consoles. Place the point of a scratch awl against the center inside front lip of the headliner ring (inside edge of the shade tray). Pierce the headliner, and make a slight dent in the roof panel that will be easily visible on top of the vehicle 5. Carefully remove the entire headliner board from the vehicle. 6. If applicable, remove anti-flutter roof bows from the inside of the roof. Do not remove, cut or modify any structural braces, headers or side rails. 7. Measure and mark a front-to-rear center line on the outside of the roof with a marking pencil. Draw a “reference mark” crossing the center line at the roof dent made in step 4. Measure and mark the front cut line 1¼ inches in front of this reference mark. 8. Align the template centerline to centerline on roof. Align front arrow on the template to front cut line mark. Tape template in place, and apply 2 inch wide masking tape around the outside of the cut line to protect the paint while cutting the roof panel. 9. Make a hole large enough to allow entry of the cutting tool, 1 to 3 inches inside the cut line. If necessary, enlarge the hole using hand held metal snips. Cut the sunroof opening with a suitable metal cutting tool. 10. Use a file to clean up any rough edges or burrs around the sunroof opening. 11. Test fit the sunroof. Trim the hole if required and retest. There should be approximately 1/8 inch (4 mm) clearance front to rear, and side to side. Once proper fit has been achieved, remove the masking tape [ peel inward, toward the opening ] and marking pencil lines from the roof. 12. Apply bare metal primer to the cut edge to prevent the metal from rusting. 13. Clean underside of main frame with wax/grease remover. Apply sealant to the inside lip of the main frame. Use nonacidic silicone, butyl, or the supplied foam tape. If using foam or butyl tape, fully overlap the ends in the rear center at a screw hole. Kit includes foam sealant tape, however some technicians prefer silicone or butyl

Related Content:

Webasto Sunroof Problems, Inalfa Sunroof Problems, Webasto Sunroof Reset, inalfa sunroof reset, inalfa sunroof repair, inalfa roof systems water leak repair, Webasto Troubleshooting and Repair sunroof, sunroof motor trouble shooting, rotunda ford evap system standards price, 2001 yukon sunroof problems

Viewing all articles
Browse latest Browse all 2

Latest Images

Trending Articles





Latest Images